Entry-level oxygen cutting system, great for often-changing cutting requirements and production schedules. A proven production cutting system with an attractive initial capital cost.
Capacity
Mild Steel |
Dross free
Production
(pierce)
Severence
(edge starts) |
25 mm (1")
25 mm (1")
50 mm (2")
|
| Stainless Steel |
Production
(pierce)
Severence
(edge starts) |
25 mm (1")
50 mm (2") |
| Aluminum |
Production (pierce)
Severence (edge starts) |
25 mm (1")
50 mm (2") |
Speed*
(Mild steel) |
Optimum quality |
12 mm (1/2")
2159 mm/m
(85 ipm) |
| Cut angle |
ISO 9013
range** |
4-5 |
| Weldability |
|
Ready to weld |
Process gases
by material
(Plasma/shield) |
Mild steel
Stainless steel
Aluminum
|
Air/Air,
O2/Air,
N2, CO2
Air/Air, N2/Air,
N2/CO2,
H35/N2
Air/Air, N2/Air,
N2/CO2,
H35/N2 |
| Process amps |
Not all processes available
for all materials |
40-200
beveling (200) |
* Note: Take care in comparison: competitors often show maximum cutting speeds rather than speeds that deliver the best cuts, as shown above. Cut speeds listed above deliver best cut quality, but cut speeds can be up to 50% faster.
** ISO 9013 is a standard that defines cut quality of thermally cut parts. The lower the range (range 1 is the lowest), the smaller the angle on the cut face. Cut angle in range 4 is better than in range 5.
